Numerische Optimierung dreidimensional parametrisierter ...

[23] Frank, P. D.; Booker, A. J.; Caudell, T. P.; Healy, M. J.: A Comparison of Optimization
and Search Methodes for Multidisciplinary Design.
AIAA-92-4827-CP, 1992.
[24] Fottner, L.: Review on Turbomachinery Blading Design.
AGARD Lecture Series "Blading Design for Axial Turbomachines", No. 167, 1989.
[25] Gauger, N.; Mauß, M.: Das Adjungiertenverfahren in der aerodynamischen Optimierung
von Turbomaschinen.
Institut für Aerodynamik und Strömungstechnik, DLR, Braunschweig, Institutsbericht
129-2001/22, 2001.
[26] Gehrer, A.; Passrucker, H.; Jericha, H.; Lang, J.: Blade Design and Grid Generation for
Computational Fluid Dynamics (CFD) with Bézier-Curves and Bézier-Surfaces.
Turbomachinery - Fluid Dynamics and Thermodynamics, 1997.
[27] Giannakoklou, K. C.: Designing Turbomachinery Blades using Evolutionary Methods.
ASME-99-GT-181, 1999.
[28] Gier, J.; Ardey, S.; Heisler, A.: Analysis of Complex Three-Dimensional Flow in a Three-
Stage Turbine by Means of Transitional Navier-Stokes Simulation.
ASME 2000-GT-645, 2000.
[29] Griewank, A.: Evaluating Derivatives, Principles and Techniques of Algorithmic Differentiation.
Frontiers in Applied Mathematics, SIAM, 2000.
[30] Hager, J. O.; Eyi, S.; Lee, K. D.: A Multi-Point Optimization for Transonic Airfoil
Design.
AIAA-92-4681-CP, 1992.
[31] Happel, H.: Rechenverfahren zur Turbomaschinenauslegung.
Arbeitsunterlagen zur Vorlesung, Universität der Bundeswehr München, 2000.
[32] Hartland, J. C.; Gregory-Smith, D. G.; Harvey, N. W.; Rose, M. G.: Non-Axisymmetric
Turbine Endwall Design, Part II: Experimental Validation.
ASME 99-GT-338, 1999.
[33] Hartland, J. C.; Gregory-Smith, D. G.; Rose, M. G.: Non-Axisymmetric Endwall Profiling
in a Turbine Rotor Blade.
ASME 98-GT-525, 1998.
112