v5.20 - Classic DocuShare Home - Trimble

In the Field 5
You can use this form to view or change the offset from the GPS
position to the feature. PressOto open the offset form for the
feature type (for example, Point offset for a point feature), then enter
the offset details. You can enter the offset as a bearing, slope distance,
and inclination, or as a bearing, horizontal distance, and vertical
distance. Pressfto switch between the two options. \ Press to
confirm the offset and return to the Averaged position form.
To make a waypoint at the position shown, pressw. The caption of
the form changes to Create waypoint #,where# represents the next
available waypoint number.
Waypoints created in the Asset Surveyor software are assigned
sequential numbers as identifiers, but are usually referred to by name:
You can change the name of the waypoint, which defaults to the
feature name. You can also edit its latitude, longitude, or altitude. To
confirm the new waypoint and return to the Averaged position form,
press \.
TSC1 Asset Surveyor Operation Manual 101