v5.20 - Classic DocuShare Home - Trimble

I Laser Rangefinders
Configuring the Asset Surveyor software
Configure the special Laser sensor to work with the LaserCraft
Contour XLR. To do this, press theSsoftkey. The Laser
range-finder configuration form appears:
Set the Type field to ‘Contour XLR’. If you generally use the Contour
XLR rangefinder when collecting data, and if you typically do not use
any other type of external sensor, then set the Auto-connect field to
‘Yes’.
Set the Confirm offsets fieldto‘On’todisplaytheOffset form for the
currently open feature whenever you send an offset from a laser
rangefinder.
Set the Confirm offsets field to ‘Off’ to automatically record offset
values to the open feature when you fire the rangefinder. The Offset
form does not appear unless an entry is required. The message Offset
received appears briefly in the status line, but no other notification
appears unless an entry is required. You can pressOin the attribute
entryformtoopentheOffset form if you want to confirm offset
values.
Set the Serial port according to the port you connect the LaserCraft
Contour XLR to, either ‘Top’ or ‘Bottom’.
\ Press to save these settings and return to the Select sensor menu.
396 TSC1 Asset Surveyor Operation Manual