v5.20 - Classic DocuShare Home - Trimble

Laser Rangefinders I
I.5.3 Configuration for Use with the Asset Surveyor Software
This section provides instructions for configuring the LEDHA-GEO
laser binoculars for use with the Asset Surveyor software.
1. In the Asset Surveyor software’s External Sensors
configuration, select Laser and choose LEDHA-GEO as the
type.
2. Connect the cable from the LEDHA to the datalogger.
3. Turn on the LEDHA and press the MODE button until B is
selected.
4. Press PROGR until 1 is selected.
5. Turn the LEDHA off.
6. While holding down the LEDHA’s Memory button, press
MODE or PROGR to turn it on. Continue holding down the
Memory button until the display appears in the LEDHA’s
viewer.
7. The configured baud rate should appear in the display, for
example, baud 9k6. Using the ‘+’ and ‘-’ keys, change the baud
rate to 4k8.
8. Press the Memory key to move to the next option.
9. When the Frame settings appear, change the setting to 8N1,
again using the ‘+’ and ‘-’ keys to change the value and
Memory to move to the next setting.
10. When Display appears, use ‘+’ and ‘-’ to set the brightness of
the display.
11. The next option is the units to display for distance. Select
whichever units you would like to see. This setting has no effect
on the units displayed or stored by the Asset Surveyor software
(this can be configured within the datalogger).
12. The next option is the Velocity units. This doesn’t need to be
changed because angles are not displayed within the LEDHA
when taking measurements for the Asset Surveyor software.
TSC1 Asset Surveyor Operation Manual 365