v5.20 - Classic DocuShare Home - Trimble

A.5.3 RTCM Output
Pro XRS System A
The Pro XRS receiver supports RTCM output as a receiver firmware
option. The Asset Surveyor software can configure and control a realtime
base station provided the receiver is a Pro XL, Pro XR, Pro XRS,
Series 4000, Site Surveyor 4400, GPS Total Station 4700, or GPS
Total Station 4800 and has the appropriate firmware option installed.
The Pro XRS receiver can be operated as an Unattended Real-time
Base Station without a datalogger if you have the appropriate cable.
The Unattended Real-time Base Station power cable (P/N 32247)
supplies power to the Pro XRS receiver on Port B so that you may
remove the datalogger when using the Pro XRS receiver as an
Unattended Real-Time Base Station. Contact your local Trimble sales
office to order this accessory.
If you require the data for postprocessed differential correction, you
must have the TSC1 datalogger connected to the Pro XRS base station
at all times.
If you are using a Trimtalk 450, 450S, or 900, a Trimmark I or II,
or a new Pacific Crest RFM96W with the Pro XRS receiver you must
purchase the RTCM OUT cable (P/N 32871) which connects to the
Pro XRS receiver on Port A, replacing the NMEA/RTCM cable (P/N
30232-00). If you are using an old Pacific Crest RFM96W with the
Pro XRS receiver you must purchase the RTCM OUT cable (P/N
33346). The RTCM OUT cable has a Lemo connector on the other end
for connection to the radios listed above.
Note – A Lemo adapter cable, supplied by Pacific Crest, is required to
connect the RTCM OUT cable (P/N 32871) to the RFM96W radio.
If you are using a non-Trimble radio with the Pro XRS receiver, you
must have your own cable to connect from your radio to the supplied
NMEA/RTCM cable in Port A.
TSC1 Asset Surveyor Operation Manual 235