v5.20 - Classic DocuShare Home - Trimble

5 In the Field
Target and Start
If a feature in the Review data list is selected as the navigation Target,
the Target waypoint icon appears over it on the map. This is the
same as the normal waypoint icon except that it is larger. If the Target
is off the screen, the bearing to go arrow appears to show you the
direction the Target is in.
You can also use the map to select a Target. Use the cursor to highlight
the feature or waypoint you wish to navigate to and pressG, or
pressGand choose your destination from the Select target menu
that appears.
In the map you can also select a place to start navigating from by
pressingT. The Start is marked with the Start icon . The Start,
like the Target, may be a waypoint, a point feature, the start or end of a
line or area feature, or the center of an area feature.
When you select both a Start and a Target, and the Navigation layer of
the map is enabled, a dashed ‘cross-track’ line appears between the
Start and Target, representing the direct route between the two
locations. You can use this trail as a basic navigation guide to reach
the Target.
124 TSC1 Asset Surveyor Operation Manual