v5.20 - Classic DocuShare Home - Trimble

In the Field 5
If a feature has already been marked, the)softkeyappearsinthe
attribute form instead. Press this softkey to reset the feature status to
Imported. You cannot use)to reset features which have been
updated by changing attributes, offsets, or GPS positions.
Updating two features at a time
You can have up to two features open at the same time: either a new
feature and an existing feature, or two existing features. However,
because you can only log GPS position information for one point at a
time, the Asset Surveyor software only lets you record GPS positions
for one of the open features. The second feature may be viewed, and
its attributes updated, but you cannot change its position information
until you close the other feature. The text (edit only) appears in the
title of the attribute entry form for the second feature.
The edit-only feature need not be the last feature you opened. You can
open a feature (and optionally edit its attributes) without updating its
GPS position, then open another feature and begin logging GPS data
for it. The first feature you opened then becomes edit-only, and cannot
be updated in full until you close the second feature.
A new feature can only be opened for full update, and is never editonly.
Even if you have paused logging, opening a new feature makes
any other open feature edit-only. However, you must always stop
logging for one feature before you begin logging for another one. If
you are already logging GPS positions for an existing feature, the
Asset Surveyor software will not let you open a new feature until you
close the existing one.
TSC1 Asset Surveyor Operation Manual 111