v5.20 - Classic DocuShare Home - Trimble

D Series 4000
The Asset Surveyor software should now be able to
communicate with the Series 4000 receiver. If it cannot, the
most likely cause of the problem is incorrectly connected or
faulty cabling. Check that you have connected the receiver and
TSC1 datalogger as shown in the cabling diagram later in this
section. If the cabling is connected correctly and the Asset
Surveyor software still cannot communicate with the Series
4000 receiver, contact your Trimble Assistance Center to have
the cabling checked.
Note – Some versions of the Series 4000 GPS receiver firmware do not
reset the baud rate and serial parameters when you reset to DEFAULT
CONTROLS. You may have to manually reset the receiver’s Port 1 to
9600-8-ODD-1 before the Asset Surveyor software can communicate
with the GPS receiver.
D.5 Operational Aspects Specific to Series 4000 GPS
Receivers
D.5.1 Real-Time Input
There are a number of aspects in which the Series 4000 GPS receivers
differ from the GPS Pathfinder receivers.
The Series 4000 receiver with the Asset Surveyor software supports
the RTCM version 2.1 and CMR formats for RTK/RTCM input.
D.5.2 Real-Time Output
The Series 4000 receiver with the Asset Surveyor software supports
the RTCM version 2.1 and CMR formats for RTK/RTCM output.
264 TSC1 Asset Surveyor Operation Manual