Management Guide - Kamery IP

3Configuring the SwitchConfiguring sFlow Port ParametersUse the sFlow Port Configuration page to set the destination parameters for thesampled data, payload parameters, and sampling interval.Command Usage• Port – Choose the port to configure. (Range: 1-28/52; Default: 1)• Receiver Owner 4 – The name of the receiver. (Range: 1-256 characters;Default: None)• Receiver IP Address 4 – IP address of the sFlow Collector.• Receiver Port 4 – The UDP port on which the sFlow Collector is listening for sFlowstreams. (Range: 0-65534; Default: 6343)• Time Out – The time that the sFlow process will continuously send samples to theCollector before resetting all sFlow port parameters (receiver owner, time out, maxheader size, max datagram size, and flow interval). A time out value of 0 secondsindicates no time out. (Range: 0-10000000 seconds; Default: 0 seconds)The check box is cleared by the system if flow sampling is currently under way.To change the timeout, mark the check box, enter a timeout value, and click Apply.• Max Header Size – Maximum size of the sFlow datagram header.(Range: 64-256 bytes; Default: 128 bytes)• Max Datagram Size – Maximum size of the sFlow datagram payload.(Range: 200-1500 bytes; Default: 1400 bytes)• Flow Interval – The interval at which the sFlow process adds counter values to thesample datagram. An interval of 0 seconds effectively disables this feature.(Range: 0-10000000 seconds; Default: 0 seconds)4. Sampling must be disabled by setting the time out to 0 before these fields can be configured.3-68