Management Guide - Kamery IP

4Command Line InterfaceCommand ModePrivileged ExecExampleConsole#show policy-map interface ethernet 1/5Service-policy rd-policy inputConsole#Multicast Filtering CommandsThis switch uses IGMP (Internet Group Management Protocol) to query for anyattached hosts that want to receive a specific multicast service. It identifies the portscontaining hosts requesting a service and sends data out to those ports only. It thenpropagates the service request up to any neighboring multicast switch/router toensure that it will continue to receive the multicast service.Table 4-93 Multicast Filtering CommandsCommand Groups Function PageIGMP SnoopingConfigures multicast groups via IGMP snooping or staticassignment, sets the IGMP version, displays current snooping andquery settings, and displays the multicast service and groupmembers4-384IGMP Query Configures IGMP query parameters for multicast filtering at Layer 2 4-389Static Multicast Routing Configures static multicast router ports which forwards all inbound 4-393multicast traffic to the attached VLANsIGMP Filtering and Throttling Configures IGMP filtering and throttling 4-395Multicast VLAN Registration Configures a single network-wide multicast VLAN shared by hostsresiding in other standard or private VLAN groups, preservingsecurity and data isolation for normal traffic4-401IGMP Snooping CommandsThis section describes commands used to configure IGMP snooping on the switch.Table 4-94IGMP Snooping CommandsCommand Function Mode Pageip igmp snooping Enables IGMP snooping GC 4-385ip igmp snooping vlan static Adds an interface as a member of a multicast group GC 4-385ip igmp snooping version Configures the IGMP version for snooping GC 4-386ip igmp snoopingEnables IGMP leave proxy on the switch GC 4-387leave-proxyip igmp snoopingimmediate-leaveEnables IGMP immediate leave for a VLAN interface IC 4-3874-384