Management Guide - Kamery IP

4Command Line Interface• The maximum number of user-defined configuration files depends onavailable memory.• You can use “Factory_Default_Config.cfg” as the source to copy from thefactory default configuration file, but you cannot use it as the destination.• To replace the startup configuration, you must use startup-config as thedestination.• The Boot ROM and Loader can be downloaded from an FTP/TFTP server, butcannot be uploaded from the switch to a file server.• For information on specifying an https-certificate, see “Replacing the DefaultSecure-site Certificate” on page 3-89. For information on configuring theswitch to use HTTPS for a secure connection, see “ip http secure-server” onpage 4-133.• When logging into an FTP server, the interface prompts for a user name andpassword configured on the remote server. Note that “anonymous” is set asthe default user name.ExampleThe following example shows how to download new firmware from a TFTP server:Console#copy tftp fileTFTP server ip address: 10.1.0.19Choose file type:1. config: 2. opcode: : 2Source file name: V3.1.16.20.BIXDestination file name: V311620\Write to FLASH Programming.-Write to FLASH finish.Success.Console#The following example shows how to upload the configuration settings to a file onthe TFTP server:Console#copy file tftpChoose file type:1. config: 2. opcode: : 1Source file name: startupTFTP server ip address: 10.1.0.99Destination file name: startup.01TFTP completed.Success.Console#The following example shows how to copy the running configuration to a startup file.Console#copy running-config filedestination file name: startupWrite to FLASH Programming.\Write to FLASH finish.Success.Console#4-38