Management Guide - Kamery IP

Authentication Commands4Management IP Filter CommandsThis section describes commands used to configure IP management access to theswitch.Table 4-40 IP Filter CommandsCommand Function Mode Pagemanagement Configures IP addresses that are allowed management access GC 4-155show management Displays the switch to be monitored or configured from abrowserPE 4-156managementThis command specifies the client IP addresses that are allowed managementaccess to the switch through various protocols. Use the no form to restore thedefault setting.Syntax[no] management {all-client | http-client | snmp-client | telnet-client}start-address [end-address]• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.• http-client - Adds IP address(es) to the web group.• snmp-client - Adds IP address(es) to the SNMP group.• telnet-client - Adds IP address(es) to the Telnet group.• start-address - A single IP address, or the starting address of a range.• end-address - The end address of a range.Default SettingAll addressesCommand ModeGlobal ConfigurationCommand Usage• If anyone tries to access a management interface on the switch from an invalidaddress, the switch will reject the connection, enter an event message in thesystem log, and send a trap message to the trap manager.• IP address can be configured for SNMP, web and Telnet access respectively.Each of these groups can include up to five different sets of addresses, eitherindividual addresses or address ranges.• When entering addresses for the same group (i.e., SNMP, web or Telnet), theswitch will not accept overlapping address ranges. When entering addressesfor different groups, the switch will accept overlapping address ranges.• You cannot delete an individual address from a specified range. You mustdelete the entire range, and reenter the addresses.• You can delete an address range just by specifying the start address, or byspecifying both the start address and end address.4-155