Management Guide - Kamery IP

Multicast Filtering Commands4show mac-address-table multicastThis command shows known multicast addresses.Syntaxshow mac-address-table multicast [vlan vlan-id] [user | igmp-snooping]• vlan-id - VLAN ID (1 to 4092)• user - Display only the user-configured multicast entries.• igmp-snooping - Display only entries learned through IGMP snooping.Default SettingNoneCommand ModePrivileged ExecCommand UsageMember types displayed include IGMP or USER, depending on selectedoptions.ExampleThe following shows the multicast entries learned through IGMP snooping forVLAN 1:Console#show mac-address-table multicast vlan 1 igmp-snoopingVLAN M'cast IP addr. Member ports Type---- --------------- ------------ -------1 224.1.2.3 Eth1/11 IGMPConsole#IGMP Query Commands (Layer 2)This section describes commands used to configure Layer 2 IGMP query on theswitch.Table 4-95 IGMP Query Commands (Layer 2)Command Function Mode Pageip igmp snooping querier Allows this device to act as the querier for IGMP snooping GC 4-390ip igmp snoopingConfigures the query count GC 4-390query-countip igmp snoopingConfigures the query interval GC 4-391query-intervalip igmp snoopingConfigures the report delay GC 4-391query-max-response-timeip igmp snoopingrouter-port-expire-timeConfigures the query timeout GC 4-3924-389