Management Guide - Kamery IP

System Management Commands4sntp serverThis command sets the IP address of the servers to which SNTP time requests areissued. Use the this command with no arguments to clear all time servers from thecurrent list.Syntaxsntp server [ip1 [ip2 [ip3]]]ip - IP address of a time server (NTP or SNTP).(Range: 1-3 addresses)Default SettingNoneCommand ModeGlobal ConfigurationCommand UsageThis command specifies time servers from which the switch will poll for timeupdates when set to SNTP client mode. The client will poll the time servers inthe order specified until a response is received. It issues time synchronizationrequests based on the interval set via the sntp poll command.ExampleConsole(config)#sntp server 10.1.0.19Console(config)#Related Commandssntp client (4-68)sntp poll (4-69)show sntp (4-70)sntp pollThis command sets the interval between sending time requests when the switch isset to SNTP client mode. Use the no form to restore to the default.Syntaxsntp poll secondsno sntp pollseconds - Interval between time requests. (Range: 16-16384 seconds)Default Setting16 secondsCommand ModeGlobal Configuration4-69