Management Guide - Kamery IP

4Command Line Interfacespeed/duplex mode under auto-negotiation, the required mode must bespecified in the capabilities list for an interface.ExampleThe following example configures port 5 to 100 Mbps, half-duplex operation.Console(config)#interface ethernet 1/5Console(config-if)#speed-duplex 100halfConsole(config-if)#no negotiationConsole(config-if)#Related Commandsnegotiation (4-224)capabilities (4-225)negotiationThis command enables autonegotiation for a given interface. Use the no form todisable autonegotiation.Syntax[no] negotiationDefault SettingEnabledCommand ModeInterface Configuration (Ethernet, Port Channel)Command Usage• When auto-negotiation is enabled the switch will negotiate the best settingsfor a link based on the capabilities command. When auto-negotiation isdisabled, you must manually specify the link attributes with the speed-duplexand flowcontrol commands.• If autonegotiation is disabled, auto-MDI/MDI-X pin signal configuration willalso be disabled for the RJ-45 ports.ExampleThe following example configures port 11 to use autonegotiation.Console(config)#interface ethernet 1/11Console(config-if)#negotiationConsole(config-if)#Related Commandscapabilities (4-225)speed-duplex (4-223)4-224