Management Guide - Kamery IP

4Command Line InterfaceShowing CommandsIf you enter a “?” at the command prompt, the system will display the first level ofkeywords for the current command class (Normal Exec or Privileged Exec) orconfiguration class (Global, ACL, Interface, Line or VLAN Database). You can alsodisplay a list of valid keywords for a specific command. For example, the command“show ?” displays a list of possible show commands:Console#show ?access-groupAccess groupsaccess-listAccess listsaccountingUses an accounting list with this namearpInformation of ARP cacheauto-traffic-control Auto traffic control informationbannerBanner infobridge-extBridge extension informationcalendarDate and time informationclass-mapDisplays class mapsclusterDisplay clusterdebugState of each debugging optiondnsDNS informationdot1q-tunneldot1q-tunneldot1x802.1x contentgarpGARP propertiesgvrpGVRP interface informationhistoryHistory informationhostsHost informationinterfacesInterface informationipIP informationipv6IPv6 informationlacpLACP statisticslineTTY line informationlldpLLDPlogLogin recordsloggingLogging settingmacMAC access listmac-address-table Shows the MAC address tablemac-vlanMAC-based VLAN informationmanagementShow management informationmapMaps prioritymemoryMemory utilizationmvrShows MVR global parametersnetwork-access Shows the entries of the secure port.ntpNetwork Time Protocol configurationpolicy-mapDisplays policy mapsportPort characteristicsprivilegeShows current privilege levelprocessDevice processprotocol-vlanProtocol-VLAN informationpublic-keyPublic key informationpvlanShows the Private VLAN informationqueuePriority queue informationradius-serverRADIUS server informationreloadShows the reload settingsrunning-config Information on the running configurationsflowShows the sflow informationsnmpSimple Network Management Protocol statisticssntpSimple Network Time Protocol configurationspanning-treeSpanning-tree configurationsshSecure shell server connections4-4