Management Guide - Kamery IP

Power Over Ethernet Settings3Web – Click PoE, Power Port Status.Figure 3-112 Displaying Port PoE StatusCLI – This example displays the PoE status and priority of port 1.Console#show power inline status 4-271Unit: 1Compatible mode : EnabledMax Used OverloadInterface Admin Oper Power Power Priority Auto-recover--------- -------- ---- -------- -------- -------- ------------Eth 1/ 1 Enabled Off 15400 mW 0 mW Low DisabledEth 1/ 2 Enabled Off 15400 mW 0 mW Low DisabledEth 1/ 3 Enabled On 15400 mW 7505 mW Low DisabledEth 1/ 4 Enabled Off 15400 mW 0 mW Low DisabledEth 1/ 5 Enabled Off 15400 mW 0 mW Low DisabledEth 1/ 6 Enabled Off 15400 mW 0 mW Low DisabledEth 1/ 7 Enabled On 15400 mW 8597 mW Low Disabled.Eth 1/23 Enabled Off 15400 mW 0 mW Low DisabledEth 1/24 Enabled Off 15400 mW 0 mW Low DisabledConsole#Configuring Port PoE PowerIf a device is connected to a switch port and the switch detects that it requires morethan the power budget of the port, no power is supplied to the device (i.e., portpower remains off).If the power demand from devices connected to switch ports exceeds the powerbudget set for the switch, the port power priority settings are used to control thesupplied power. For example:• If a device is connected to a low-priority port and causes the switch to exceed itsbudget, port power is not turned on.• If a device is connected to a critical or high-priority port and causes the switch toexceed its budget, port power is turned on, but the switch drops power to one ormore lower-priority ports.Note: Power is dropped from low-priority ports in sequence starting from port number 1.3-189