Management Guide - Kamery IP

4Command Line InterfaceCommand ModeGlobal ConfigurationCommand UsageWhen LLDP is re-initialized on a port, all information in the remote systemsLLDP MIB associated with this port is deleted.ExampleConsole(config)#lldp reinit-delay 10Console(config)#lldp tx-delayThis command configures a delay between the successive transmission ofadvertisements initiated by a change in local LLDP MIB variables. Use the no formto restore the default setting.Syntaxlldp tx-delay secondsno lldp tx-delayseconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)Default Setting2 secondsCommand ModeGlobal ConfigurationCommand Usage• The transmit delay is used to prevent a series of successive LLDPtransmissions during a short period of rapid changes in local LLDP MIBobjects, and to increase the probability that multiple, rather than singlechanges, are reported in each transmission.• This attribute must comply with the following rule:(4 * tx-delay) ≤ refresh-intervalExampleConsole(config)#lldp tx-delay 10Console(config)#4-350