Management Guide - Kamery IP

3Configuring the SwitchWeb – Specify the action (i.e., Permit or Deny). Specify the source and/ordestination addresses. Select the address type (Any, Host, or MAC). If you select“Host,” enter a specific address (e.g., 11-22-33-44-55-66). If you select “MAC,” entera base address and a hexadecimal bitmask for an address range. Set any otherrequired criteria, such as VID, Ethernet type, or packet format. Then click Add.Figure 3-79 ACL Configuration - MACCLI – This example configures one permit rule for all source mac addresses tocommunicate with all destination mac addresses on VLAN 12, and another permitrule for source mac address to communicate with all destination mac addresses.Console(config-mac-acl)#permit any any vid 12 4095 4-215Console(config-mac-acl)#permit host 00-10-b5-e9-52-79 anyConsole(config-mac-acl)#3-132