Management Guide - Kamery IP

4Command Line InterfaceFieldStatusImmediate LeaveTable 4-100show mvr interface - display description (Continued)DescriptionShows the MVR status and interface status. MVR status for source ports is“ACTIVE” if MVR is globally enabled on the switch. MVR status for receiverports is “ACTIVE” only if there are subscribers receiving multicast traffic fromone of the MVR groups, or a multicast group has been statically assigned toan interface.Shows if immediate leave is enabled or disabled.The following shows information about the interfaces associated with multicastgroups assigned to the MVR VLAN:Console#show mvr membersMVR Group IP Status Receiver VLAN Members---------------- -------- ------------- -------225.0.0.1 ACTIVE VLAN2 eth1/1(d), eth1/2(s)225.0.0.2 INACTIVE None None225.0.0.3 INACTIVE None None225.0.0.4 INACTIVE None None225.0.0.5 INACTIVE None None225.0.0.6 INACTIVE None None225.0.0.7 INACTIVE None None225.0.0.8 INACTIVE None None225.0.0.9 INACTIVE None None225.0.0.10 INACTIVE None NoneConsole#FieldMVR Group IPStatusReceiver VLANMembersTable 4-101show mvr members - display descriptionDescriptionMulticast groups assigned to the MVR VLAN.Shows whether or not the there are active subscribers for this multicast group. Note thatthis field will also display “INACTIVE” if MVR is globally disabled.VLAN used to froward multicast traffic with tagged frames without revealing the identity ofthe MVR VLANShows the interfaces with subscribers for multicast services provided through the MVRVLAN. Also shows if an interface has dynamically joined a multicast group (d), or if amulticast group has been statically bound to the interface (s).The following shows the interfaces which have joined MVR receiver groups, and thestatus of MVR traffic for each group:Console#show mvr receiver-group membersMVR Group IP Status Members---------------- -------- -------224.0.0.1 ACTIVE eth1/1224.0.0.2 INACTIVE None224.0.1.1 INACTIVE None224.0.1.2 INACTIVE None224.0.1.3 INACTIVE NoneConsole#4-408