Management Guide - Kamery IP

Port Configuration3Web – Click Port, Port/Trunk Broadcast Control. Set the threshold, mark theEnabled field for the desired interface and click Apply.Figure 3-102 Port Broadcast ControlCLI – Specify any interface, and then enter the threshold. The following disablesbroadcast storm control for port 1, and then sets broadcast suppression at 500kilobits per second for port 2.Console(config)#interface ethernet 1/1 4-222Console(config-if)#no switchport broadcast 4-229Console(config-if)#exitConsole(config)#interface ethernet 1/2Console(config-if)#switchport broadcast packet-rate 500 4-229Console(config-if)#endConsole#show interfaces switchport ethernet 1/2 4-233Information of Eth 1/2Broadcast Threshold:Enabled, 500 Kbits/secondMulticast Threshold:DisabledUnknown-unicast Threshold: DisabledLACP Status:DisabledIngress Rate Limit:Disabled, 100000 Kbits per secondEgress Rate Limit:Disabled, 100000 Kbits per secondVLAN Membership Mode:HybridIngress Rule:EnabledAcceptable Frame Type:All framesNative VLAN: 1Priority for Untagged Traffic: 0GVRP Status:DisabledAllowed VLAN:1(u),Forbidden VLAN:Private-VLAN Mode:NONEPrivate-VLAN Host-association: NONEPrivate-VLAN Mapping:NONE802.1Q-tunnel Status:Disable802.1Q-tunnel Mode:NORMAL802.1Q-tunnel TPID:8100(Hex)3-173