Management Guide - Kamery IP

IP Interface Commands4• If you select the bootp or dhcp option, IP is enabled but will not function untila BOOTP or DHCP reply has been received. Requests will be broadcastperiodically by this device in an effort to learn its IP address. (BOOTP andDHCP values can include the IP address, default gateway, and subnet mask).• If the DHCP/BOOTP server is slow to respond, you may need to use the ipdhcp restart command to re-start broadcasting service requests.Note: Only one VLAN interface can be assigned an IP address (the default isVLAN 1). This defines the management VLAN, the only VLAN throughwhich you can gain management access to the switch. If you assign an IPaddress to any other VLAN, the new IP address overrides the original IPaddress and this becomes the new management VLAN.ExampleIn the following example, the device is assigned an address in VLAN 1.Console(config)#interface vlan 1Console(config-if)#ip address 192.168.1.5 255.255.255.0Console(config-if)#Related Commandsip dhcp restart (4-418)ip default-gatewayThis command establishes a static route between this switch and devices that existon another network segment. Use the no form to remove the static route.Syntaxip default-gateway gatewayno ip default-gatewaygateway - IP address of the default gatewayDefault SettingNo static route is established.Command ModeGlobal ConfigurationCommand Usage• A gateway must be defined if the management station is located in a differentIP segment.• An default gateway can only be successfully set when a network interface thatdirectly connects to the gateway has been configured on the switch.ExampleThe following example defines a default gateway for this device:Console(config)#ip default-gateway 10.1.1.254Console(config)#4-417