Management Guide - Kamery IP

VLAN Commands4subnet-vlanThis command configures IP Subnet VLAN assignments. Use the no form to removean IP subnet-to-VLAN assignment.Syntaxsubnet-vlan subnet ip-address mask vlan vlan-idno subnet-vlan subnet {ip-address mask | all}• ip-address – The IP address that defines the subnet. Valid IP addressesconsist of four decimal numbers, 0 to 255, separated by periods.• mask – This mask identifies the host address bits of the IP subnet.• vlan-id – VLAN to which matching IP subnet traffic is forwarded.(Range: 1-4094)Default SettingNoneCommand ModeGlobal ConfigurationCommand Usage• Each IP subnet can be mapped to only one VLAN ID. An IP subnet consistsof an IP address and a subnet mask.• When an untagged frame is received by a port, the source IP address ischecked against the IP subnet-to-VLAN mapping table, and if an entry isfound, the corresponding VLAN ID is assigned to the frame. If no mapping isfound, the PVID of the receiving port is assigned to the frame.• The IP subnet cannot be a broadcast or multicast IP address.• When MAC-based, IP subnet-based, and protocol-based VLANs aresupported concurrently, priority is applied in this sequence, and thenport-based VLANs last.ExampleThe following example assigns traffic for the subnet 192.168.12.192, mask255.255.255.224, to VLAN 4.Console(config)#subnet-vlan subnet 192.168.12.192 255.255.255.224 vlan 4Console(config)#show subnet-vlanThis command displays IP Subnet VLAN assignments.Command ModePrivileged ExecCommand Usage• Use this command to display subnet-to-VLAN mappings.• The last matched entry is used if more than one entry can be matched.4-335