Management Guide - Kamery IP

4Command Line Interfacelogging trapThis command enables the logging of system messages to a remote server, orlimits the syslog messages saved to a remote server based on severity. Use thiscommand without a specified level to enable remote logging. Use the no form todisable remote logging.Syntaxlogging trap [level]no logging traplevel - One of the level arguments listed below. Messages sent include theselected level up through level 0. (Refer to the table on page 4-58.)Default Setting• Enabled• Level 7 - 0Command ModeGlobal ConfigurationCommand Usage• Using this command with a specified level enables remote logging and setsthe minimum severity level to be saved.• Using this command without a specified level also enables remote logging, butrestores the minimum severity level to the default.ExampleConsole(config)#logging trap 4Console(config)#clear logThis command clears messages from the log buffer.Syntaxclear log [flash | ram]• flash - Event history stored in flash memory (i.e., permanent memory).• ram - Event history stored in temporary RAM (i.e., memory flushed onpower reset).Default SettingFlash and RAMCommand ModePrivileged ExecExampleConsole#clear logConsole#4-60