Management Guide - Kamery IP

4Command Line InterfaceExampleThe following shows LACP enabled on ports 11-13. Because LACP has also beenenabled on the ports at the other end of the links, the show interfaces statusport-channel 1 command shows that Trunk 1 has been established.Console(config)#interface ethernet 1/11Console(config-if)#lacpConsole(config-if)#exitConsole(config)#interface ethernet 1/12Console(config-if)#lacpConsole(config-if)#exitConsole(config)#interface ethernet 1/13Console(config-if)#lacpConsole(config-if)#exitConsole(config)#exitConsole#show interfaces status port-channel 1Information of Trunk 1Basic information:Port Type:100TXMac Address:00-12-CF-12-34-72Configuration:Name:Port Admin:UpSpeed-duplex:AutoCapabilities:10half, 10full, 100half, 100fullFlow Control:DisabledVLAN Trunking:DisabledPort Security:DisabledMax MAC Count: 0Giga PHY mode:Auto preferred masterCurrent Status:Created by:LACPLink Status:UpPort Operation Status: UpOperation Speed-duplex: 100fullFlow Control Type: NoneMember Ports: Eth1/11, Eth1/12, Eth1/13,Console#lacp system-priorityThis command configures a port's LACP system priority. Use the no form to restorethe default setting.Syntaxlacp {actor | partner} system-priority priorityno lacp {actor | partner} system-priority• actor - The local side an aggregate link.• partner - The remote side of an aggregate link.• priority - This priority is used to determine link aggregation group (LAG)membership, and to identify this device to other switches during LAGnegotiations. (Range: 0-65535)Default Setting327684-254