Management Guide - Kamery IP

4Command Line InterfaceExampleConsole(config)#interface eth 1/2Console(config-if)#dot1x timeout quiet-period 350Console(config-if)#dot1x timeout re-authperiodThis command sets the time period after which a connected client must bere-authenticated. Use the no form of this command to reset the default.Syntaxdot1x timeout re-authperiod secondsno dot1x timeout re-authperiodseconds - The number of seconds. (Range: 1-65535)Default3600 secondsCommand ModeInterface ConfigurationExampleConsole(config)#interface eth 1/2Console(config-if)#dot1x timeout re-authperiod 300Console(config-if)#dot1x timeout tx-periodThis command sets the time that an interface on the switch waits during anauthentication session before re-transmitting an EAP packet. Use the no form toreset to the default value.Syntaxdot1x timeout tx-period secondsno dot1x timeout tx-periodseconds - The number of seconds. (Range: 1-65535)Default30 secondsCommand ModeInterface ConfigurationExampleConsole(config)#interface eth 1/2Console(config-if)#dot1x timeout tx-period 300Console(config-if)#4-150