Management Guide - Kamery IP

Basic Configuration3CLI – Enter the IP address of at least one SMTP server, set the syslog severity levelto trigger an email message, and specify the switch (source) and up to five recipient(destination) email addresses. Enable SMTP with the logging sendmail commandto complete the configuration. Use the show logging sendmail command to displaythe current SMTP configuration.Console(config)#logging sendmail host 192.168.1.4 4-63Console(config)#logging sendmail level 3 4-64Console(config)#logging sendmail source-emailbig-wheels@matel.com 4-64Console(config)#logging sendmail destination-emailchris@matel.com 4-65Console(config)#logging sendmail 4-65Console(config)#exitConsole#show logging sendmail 4-65SMTP servers-----------------------------------------------1. 192.168.1.4SMTP minimum severity level: 4SMTP destination email addresses-----------------------------------------------1. chris@matel.comSMTP source email address: big-wheels@matel.comSMTP status:Console#EnabledResetting the SystemThis feature restarts the system. You can reboot the system immediately, or you canconfigure the switch to reset after a specified amount of time.Command Attributes• Hours – Specifies the amount of hours to wait, combined with the minutes, beforethe switch resets. (Range: 0-576; Default: 0)• Minutes – Specifies the amount of minutes to wait, combined with the hours,before the switch resets. (Range: 1-34560; Default: 0)• Reset – Resets the switch after the specified time. If the hour and minute fields areblank, then the switch will reset immediately.• Refresh – Refreshes the countdown timer of a pending delayed reset.• Cancel – Cancels a pending delayed reset.Note: To rimmediately restart the switch, enter “0” in both the Hours and Minutes fields,and click Reset.3-41