Management Guide - Kamery IP

VLAN Commands4show spanning-tree mst configurationThis command shows the configuration of the multiple spanning tree.Command ModePrivileged ExecExampleConsole#show spanning-tree mst configurationMstp Configuration Information--------------------------------------------------------------Configuration name: R&DRevision level:0Instance Vlans--------------------------------------------------------------0 1,3-40941 2Console#VLAN CommandsA VLAN is a group of ports that can be located anywhere in the network, butcommunicate as though they belong to the same physical segment. This sectiondescribes commands used to create VLAN groups, add port members, specify howVLAN tagging is used, and enable automatic VLAN registration for the selectedinterface.Table 4-73 VLAN Command GroupsCommand Groups Function PageGVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning; 4-304shows the configuration for bridge extension MIBEditing VLAN Groups Sets up VLAN groups, including name, VID and state 4-308Configuring VLANInterfacesDisplaying VLANInformationConfiguring 802.1QTunnelingConfiguring Port-basedTraffic SegmentationConfigures VLAN interface parameters, including ingress and egresstagging mode, ingress filtering, PVID, and GVRP4-310Displays VLAN groups, status, port members, and MAC addresses 4-317Configures 802.1Q Tunneling (QinQ Tunneling) 4-318Configures traffic segmentation for different client sessions based onspecified downlink and uplink ports4-322Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-326Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-331Configuring IP Subnet Configures IP Subnet-based VLANs 4-334VLANsConfiguring MAC Based Configures MAC-based VLANs 4-336VLANsConfiguring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN 4-3384-303