install–38 - Ibm

77
Figure 14. Rail adjustment screws
Setting server ID settings
8. Remove the white screws and nuts ▌1▐ from the storage server bezel; then slide
the storage server into the rack. Align the bezel locator pins and attach the
bezel with two M6 screws ▌2▐; then install and tighten the 6-32 in. screws ▌3▐.
88
Figure 15. Server installation
9. Reverse step 1 through step 4 to reinstall the components that you removed.
See your storage server documentation to complete your installation. Store this
information with the storage server documentation for future use.
The FAStT600 comes with a server ID switch that is used to identify the FAStT600
on a fibre-channel loop. The server ID switch is located on the back of the unit, as
shown in Figure 16 on page 17.
16 IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide