install–38 - Ibm

Table 11. RAID controller LEDs (continued)
Icon LED Color Operating states 1
Expansion
port bypass
Expansion
loop
Amber v Off - Normal operation.
v On - One of the following situations has
occurred:
– An SFP module is inserted in the drive
loop port and the fibre-channel cable is
not attached to it.
– The fibre-channel cable is not attached
to an expansion unit.
– The attached expansion unit is not
turned on.
– An SFP has failed, a fibre-channel
cable has failed, or an SFP has failed
on the attached expansion unit.
Green v On - Normal operation.
v Off - The RAID controller circuitry has
failed, or the RAID controller has no
power.
2Gbps 2Gbps Green v On - Normal operation (host connection is
at 2Gbps).
v Off - Host connection is at 1Gbps (which
is not supported for controller firmware
05.33.xx.xx.
10BT 10BT Green v If the Ethernet connection is 10BASE-T:
The 10BT LED is on, 100BT LED flashes
faintly.
v If the Ethernet connection is
100BT 100BT
100BASE-T: 10BT LED is off, 100BT LED
is on.
v If there is no Ethernet connection - Both
LEDs are off.
1 Always use the storage-management software to identify the failure.
Fan fault LED
Power supply
Fan fault LED Power LED fault LEDs Power LED
Figure 36. Fan and power supply LEDs
42 IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide