install–38 - Ibm

Left ESM board Right ESM board
In port Out port Out port
Figure 33. Adding a second expansion unit
New cables
New expansion unit
First expansion unit
Storage server
with two RAID controllers
5. Remove the blank filler trays and insert drive trays. Connect power to the
storage server, and then connect power to the drive expansion enclosures. After
the enclosures are powered-on, the storage server locates the new drives.
6. Use the storage-management software to check the status of the new drives,
correct any errors found, and configure the new drives.
For more detailed information about how to cable the storage server and expansion
units, see the IBM FAStT600 Fibre Channel Cabling Instructions that come with the
storage server.
Chapter 3. Cabling the storage server 33