install–38 - Ibm

Figure 46. Installing a hot-swap power supply
To install a hot-swap power supply, perform the following steps:
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that
has this label attached. There are no serviceable parts inside these components. If you
suspect a problem with one of these parts, contact a service technician.
1. Ensure that the ac power switch is off on the power supply that you are
installing.
2. Install the power supply in the storage server, as follows:
a. Slide the power supply into the storage server. Make sure that the lever is
pulled straight out as you slide the power supply into the storage server.
b. Close the lever until the pull-ring latch locks in place. Make sure that the
lever locks into place in the storage-server chassis.
3. Wrap the strain-relief clamp around the power cord approximately 20 cm (8 in.)
from the power-supply connection end.
4. Attach the power-supply nut and tighten it securely.
5. Connect the power cord to the AC power connector. See Figure 47 on page 59.
58 IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide