2011 - Crane Cams

Lubricants
Assembly Lube (Paste)
Crane Super Moly Lube is a moly-disulfide base lubricant, for use on cam lobes, lifters and distributor
drive gears and should be used for all cam installations (except for roller lifter applications).
Advised for cup-end pushrod installation where only splash lubricant is utilized.
Also used in many areas of transmission and driveline assembly, where high initial loading occurs,
and galling should be minimized. Not recommended where normal oil flow may be impeded due
to the high viscosity of this product.
Description Part No.
Two 1-ounce packages
99002-1
1-pound container
99004-1
Crane Engine Assembly Lube is specially formulated to provide extra lubrication protection to
engine components during assembly, and to provide outstanding resistance to scuffing, wear and
friction during critical break-in. This lubricant is recommended for use on several different engine
components, such as: rocker arm fulcrum balls, needle bearings, roller tips or rocker shafts; timing
chain sprockets and gears; roller lifters and roller camshafts; engine bearing surfaces; outer surface
of hydraulic or mechanical lifter bodies (use Super Moly Lube [paste] on face of these lifters).
Description Part No.
4-ounce container
99008-1
Super Lube Break-In Concentrate For Cam & Lifter Installation
The original Crane Cams Super Lube Break-In Concentrate is an anti-wear additive formulated with a
high concentration of special zinc dithiophosphate to provide sustained protection against cam
lobe and flat-faced lifter scuffing and wear. This is especially important when using modern oils that
have been compounded for use with roller-type camshafts. This oil supplement is to be added to
the engine oil for the initial break-in period after the installation of a new camshaft and lifters.
Description Part No.
8-ounce container
99003-1
866-388-5120 • 386-236-9983 FAX 305