2011 - Crane Cams

Aluminum Shaft Mount Rocker Arms
New! Shaft Mount, Extruded Aluminum Rocker Arms - Ford FE V-8, 352-428
Crane Cams upgrades their Ford FE 352-428 V8 rocker arms offerings with a new kit incorporating aluminum rocker arms
designed with our Quick-Lift geometry. This will lift the valves off the seats quicker, promoting better torque and horsepower,
without compromising reliability. These rocker arms have the conventional Ford adjustable 1.76:1 ratio, incorporate
roller tips, and are also equipped with cup-type valve lash adjusters that permit the use of ball-and-ball configuration
pushrods. The increased stiffness of modern heavy wall pushrods can now be incorporated into your FE valve train, also
increasing power and durability, with better upper RPM stability.
This kit is designed for the Ford iron “Low Rise” cylinder heads, and the Edlebrock aluminum heads. They will also fit the
Ford FE Tunnel Port heads, if you’re fortunate enough to have a set of them. The standard oiling configuration is maintained
for bolt-on installation. Each kit contains 8 intake rockers, 8 exhaust rockers, 2 steel rocker arm shafts, a set of steel
billet stands that capture the ends of each shaft for added stability, all mounting hardware, a checking pushrod, plus installation
lubricants and complete instructions.
• Increase horsepower, torque, rpm and throttle response
• Roller tip for accurate valve stem tip tracking
• Machined steel valve lash adjusters included
• Rockers made from CNC machined, extruded billet, heat-treated aluminum
• Machined steel, hardened main shafts
• Each shaft end fully supported by steel billet shaft stands
• 1.76:1 ratio
• Stock oiling for maximum lubrication
• Fits FE iron “Low Rise” plus new Edelbrock® aluminum heads
(Does not fit Stock Medium or High-Riser heads)
• Complete kit includes shafts and all hardware
• Easy bolt-on installation with no machining required
Complete Set
Application
Ford-Mercury V-8 63-76, FE 352-360-390-406-410-427-428 cu. in
Designed For standard Low-Rise cylinder heads and Edelbrock aluminum cylinder heads
This is a complete installation kit including 8 intake rocker arms, 8 exhaust rocker arms, 2 steel
rocker shafts, steel billet shaft stands that support the ends of the shafts, all mounting hardware
Ratio Part No.
(studs, nuts, washers, shims, spacers, etc.) and complete instructions. No machining required.
Pro-Series one piece ball-and-ball end pushrods recommended for use with these rocker arms are:
1.76 34791-1
For hydraulic lifters (9.150” oal) 95819-16
For Crane hydraulic roller lifters (8.450” oal) 95805-16
For mechanical lifters (9.150” oal) 95819-16
For Crane roller lifters ( 9.050” oal) 95817-16
New rocker shafts available separately 34618-2
TECH TIP: Due to various modifications to racing engines, custom length pushrods may be required. See page 305 for special pushrod ordering instructions.
866-388-5120 • 386-236-9983 FAX 321