2011 - Crane Cams

VALVE TRAIN
Pushrods - Accessories
Adjustable Checking Pushrods
These Checking Pushrods are adjustable with over
1.000” of travel, enabling you to arrive at the correct
pushrod length to create the correct valve
train geometry for your particular engine, or when
using hydraulic lifters, to determine hydraulic lifter
preload. These pushrods are not to be run in your
engine. Once correct pushrod length is determined,
refer to our pushrod listings on pages 306-
308, or order special length pushrods on page 305. Checking Pushrods come two per package.
Application
American Motors V-8 290 thru 401
Length Diameter Part No.
Buick V-8 400 thru 455
7.500 to 8.700” 5/16” 99726-2
Chevrolet V-8 262 thru 400
8.500 to 9.800” 5/16” 99727-2
Chevrolet V-8 396 thru 454
7.500 to 8.700” 5/16” 99726-2
7.500 to 8.700” 5/16”
Chrysler “LA” V-8 273 thru 360
8.500 to 9.800” 5/16” 99730-2
Chrysler “B” V-8 Low Block 350, 361, 383, 400
6.125 to 7.500” 5/16” 99725-2
Chrysler “B” V-8 High Block 413, 426, 440
7.500 to 8.700” 5/16” 99726-2
Ford V-8 221 thru 302
8.500 to 9.800” 5/16” 99727-2
Ford V-8 Boss 302
6.125 to 7.500” 5/16” 99725-2
Ford V-8 351M-400
6.125 to 7.500” 5/16” 99725-2
Ford V-8 Boss 351, 351C, 370-429-460
8.500 to 9.800” 5/16” 99727-2
Oldsmobile V-8 260 thru 350 and 403
7.500 to 8.700” 5/16” 99726-2
Oldsmobile V-8 400, 425, 455
7.500 to 8.700” 5/16” 99726-2
Pontiac V-8 326, 389, 400, 421
8.500 to 9.800” 5/16” 99727-2
8.500 to 9.800” 5/16” 99727-2
310
CRANECAMS.COM
Section Continued