SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

SonTek/YSI
To configure the Converter for operation with the Argonaut, use the following command
sequence. A description of the Converter’s setup word is shown in the table below.
116
1. Read the existing setup word.
$1RS
*31070180
2. Write-enable the Converter EEPROM.
$1WE
*
3. Send a new setup word.
$1SU31820180
*
4. Read the new setup word to confirm it is correct.
$1RS
*31820180
5. Write-enable the Converter EEPROM, and then store the changes.
$1WE
*
$1RR
*
Converter’s Setup Word Description
Byte Purpose Setting Description
1 Address 31 Address 1
32 Address 2
33 Address 3
34 Address 4
35 Address 5
36 Address 6
37 Address 7
38 Address 8
2 COM Setting 82 9600 baud, no parity, with linefeed (default)
02 9600 baud, no parity, no linefeed (optional)
3 Advanced COM Setting 01 2-byte time delay, continuous disabled, limits
disabled, no echo (default)
4 Display Settings/Mode Select 80 6-digit display, manual mode disabled, up/down
mode (default)
Argonaut Operation Manual Firmware Version 7.9 (May 1, 2001)