SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

?
?EXIT! command, 24
+
+++ (alternative BREAK) command, 31
A
A (AvgInterval time left) command, 33
access to electronics, 55
alternative BREAK (+++) command, 31
analog board, 51
analog output option, SL/XR, 113
AnalogOutputType (AOT) command, 113
AO converter, 113
ARGONAUT.EXE, 5
ASCII output data format, 35
autonomous deployment. See deployments,
autonomous
AutoSleep (AS) command, 16
averaging interval, 2
AvgInterval (AI) command, 18, 23
B
battery housing, external, 65
battery pack replacement, 58
battery power, 1
baud rate setting, 53
beam coordinate system, 67
beam geometry, 47
binary data file format, 87
biofouling, 70, 73
BlankDistance (BD) command, 20
board locations
Argonaut MD, 48
Argonaut SL, 49
Argonaut XR, 49
BoardRev command, 16
boundary adjustment, dynamic, 2
BREAK, 2
alternative (+++), 31
definition, 10
bulkhead connector, 53
burst interval, 3
Index
Argonaut Operation Manual Firmware Version 7.9 (May 1, 2001)
burst sampling, 2, 3
BurstInterval (BI) command, 23
BurstMode (BM) command, 23
C
SonTek/YSI
C (clock adjust) command, 32
cables
and connectors, 53
maintenance, 70
power/communications, 1, 96
splitter, 1
calibration, compass, 44
Cartesian (XYZ) coordinate system, 67
CD (current deployment) command, 25
cell begin, 2
cell end, 2
CellBegin (CB) command, 19
CellEnd (CE) command, 20
CellSize (CS) command, 20
checksum calculation, 91
chip replacement, 57
cleaning transducers, 70
clock adjust (C) command, 32
command syntax, 10
commands, system, 15
Comments command, 22
communication protocol considerations, 67
communication protocols and settings, 7
communication/power cable, 53
compass
calibration, 44
commands, 28
communication, 45
installation, 40
operation, 39
testing, 39
Compass CAL command, 28
Compass command, 28
compass/tilt sensor, 1
components, 1
condensation, 70
configuration settings, hardware, 47
connectors. See cables and connectors
contact information, 85
continuous sampling, 3
119