SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West
SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West
SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SonTek</strong>/<strong>YSI</strong><br />
Setup Commands (Section 3.8)<br />
Command Short Function Parameters<br />
Temp (none) Set default temperature (°C) d.d<br />
Sal (none) Set default salinity (ppt) d.d<br />
AvgInterval AI Set averaging interval (seconds) d<br />
SampleInterval SI Set time between samples (seconds) d<br />
CellBegin CB<br />
Set start location of measurement volume<br />
(<strong>Argonaut</strong> <strong>XR</strong> and SL only)<br />
d.d<br />
CellEnd CE<br />
Set end location of measurement volume<br />
(<strong>Argonaut</strong> <strong>XR</strong> and SL only)<br />
d.d<br />
CoordSystem CY Set coordinate system for velocities<br />
BEAM, XYZ<br />
or ENU<br />
TempMode TM<br />
Set temperature used for sound speed<br />
calculations<br />
USER or<br />
MEASURED<br />
DataFormat DF Set output and stored data format<br />
LONG or<br />
SHORT<br />
ProfilingMode PM If installed, enable/disable profiling mode. YES or NO<br />
Ncells NC If PM=yes, number of cells to record d<br />
CellSize CS If PM=yes, length of range cell (m) d.d<br />
BlankDistance BD If PM=yes, distance to start of first cell (m) d.d<br />
DynBoundaryAdj<br />
<br />
DBA<br />
Set dynamic boundary adjustment mode<br />
(<strong>XR</strong> and SL with a pressure sensor only)<br />
YES or NO<br />
Deployment Commands (Section 3.9)<br />
Command Short Function Parameters<br />
Deployment (none) Set deployment name (5 characters max.) ASCII text<br />
Comments (none) Enter deployment comments ASCII text<br />
StartDate SD Set deployment start date yy/mm/dd<br />
StartTime ST Set deployment start time hh:mm:ss<br />
AvgInterval AI Set averaging interval (seconds) d<br />
SampleInterval SI Set time between samples (seconds) d<br />
BurstMode BM Enable or disable burst sampling YES or NO<br />
BurstInterval BI Set time between bursts (seconds) d<br />
SamplesPerBurst<br />
<br />
SB Set number of samples per burst d<br />
SDI-12 Interface Commands (Section 3.10)<br />
Command Short Function Parameters<br />
sdi12 (none) Places the system in the SDI-12 mode ON<br />
sdi12address (none) Sets the SDI-12 interface address d<br />
sdi12format (none) Sets the SDI-12 output data format<br />
?EXIT! (none) Exits the SDI-12 interface mode<br />
12<br />
SIDEKICK or<br />
SONTEK<br />
<strong>Argonaut</strong> Operation <strong>Manual</strong> Firmware Version 7.9 (May 1, 2001)
Change language