SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

SonTek/YSI
14
• A 3-digit termination is added to the specified file name, starting with 001 and
incrementing (002, 003, …) each time data collection is stopped and started.
• The file names use the extension .ARG. For example, if the file name is TEST, the first file
will be TEST001.ARG, followed by TEST002,ARG, etc.
Start Date and Time
• This specifies the starting date and time for the first sample in the deployment.
• If the current date and time is after the specified start date and time, the deployment will
start immediately.
• All dates and times are based on the internal Argonaut clock.
Burst Mode
• This enables or disables burst sampling mode.
• Burst sampling is not commonly used; this parameter is typically DISABLED.
• See the Argonaut Operation Manual for a description of burst sampling.
Burst Interval
• When burst-sampling mode is enabled, this sets the time from the start of one burst to the
start of the next burst.
• This parameter can only be modified when burst sampling is enabled.
• See the Argonaut Operation Manual for a description of burst sampling.
Samples Per Burst
• When burst-sampling mode is enabled, this sets the number of samples per burst.
• This parameter can only be modified when burst sampling is enabled.
• See the Argonaut Operation Manual for a description of burst sampling.
Comment 1/2/3
• Up to three comment lines are provided for you to document the data set.
Argonaut Software Manual (March 1, 2001)