SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

AvgInterval or AI [d]
• See description under Setup Commands (§3.8).
SampleInterval or SI [d]
• See description under Setup Commands (§3.8).
Argonaut Operation Manual Firmware Version 7.9 (May 1, 2001)
SonTek/YSI
BurstMode or BM [NO|YES]
• Default parameter: NO
• Without parameter: returns its current setting.
• Burst sampling can only be used in deployment mode (data collection started with the
Deploy command). In data collection mode (using the Start command), this parameter is
ignored. See §1.2 and §1.3 for a description of burst sampling.
• NO disables burst sampling; YES enables burst sampling.
BurstInterval or BI [d]
• Default parameter: 1200 (s; maximum is equivalent to 20 minutes)
• Parameter range: 1 to 43200 (s; maximum is equivalent to 12 hours)
• Without parameter: returns its current setting.
• When used with a valid integer parameter, the burst interval is set to this value (in
seconds). See §1.2 and §1.3 for a description of burst sampling.
• This command is ignored unless BurstMode is set to YES, and data collection is started
with the Deploy command.
SamplesPerBurst or SB [d]
• Default parameter: 1
• Parameter range: 1 to 1000
• Without parameter: returns its current setting.
• When used with a valid integer parameter, the number of samples per burst is set. See §1.2
and §1.3 for a description of burst sampling.
• This command is ignored unless BurstMode is set to YES, and data collection is started
with the Deploy command.
23