<strong>SonTek</strong>/<strong>YSI</strong> 118 <strong>Argonaut</strong> Operation <strong>Manual</strong> Firmware Version 7.9 (May 1, 2001)
? ?EXIT! command, 24 + +++ (alternative BREAK) command, 31 A A (AvgInterval time left) command, 33 access to electronics, 55 alternative BREAK (+++) command, 31 analog board, 51 analog output option, SL/<strong>XR</strong>, 113 AnalogOutputType (AOT) command, 113 AO converter, 113 ARGONAUT.EXE, 5 ASCII output data format, 35 autonomous deployment. See deployments, autonomous AutoSleep (AS) command, 16 averaging interval, 2 AvgInterval (AI) command, 18, 23 B battery housing, external, 65 battery pack replacement, 58 battery power, 1 baud rate setting, 53 beam coordinate system, 67 beam geometry, 47 binary data file format, 87 biofouling, 70, 73 BlankDistance (BD) command, 20 board locations <strong>Argonaut</strong> MD, 48 <strong>Argonaut</strong> SL, 49 <strong>Argonaut</strong> <strong>XR</strong>, 49 BoardRev command, 16 boundary adjustment, dynamic, 2 BREAK, 2 alternative (+++), 31 definition, 10 bulkhead connector, 53 burst interval, 3 Index <strong>Argonaut</strong> Operation <strong>Manual</strong> Firmware Version 7.9 (May 1, 2001) burst sampling, 2, 3 BurstInterval (BI) command, 23 BurstMode (BM) command, 23 C <strong>SonTek</strong>/<strong>YSI</strong> C (clock adjust) command, 32 cables and connectors, 53 maintenance, 70 power/communications, 1, 96 splitter, 1 calibration, compass, 44 Cartesian (XYZ) coordinate system, 67 CD (current deployment) command, 25 cell begin, 2 cell end, 2 CellBegin (CB) command, 19 CellEnd (CE) command, 20 CellSize (CS) command, 20 checksum calculation, 91 chip replacement, 57 cleaning transducers, 70 clock adjust (C) command, 32 command syntax, 10 commands, system, 15 Comments command, 22 communication protocol considerations, 67 communication protocols and settings, 7 communication/power cable, 53 compass calibration, 44 commands, 28 communication, 45 installation, 40 operation, 39 testing, 39 Compass CAL command, 28 Compass command, 28 compass/tilt sensor, 1 components, 1 condensation, 70 configuration settings, hardware, 47 connectors. See cables and connectors contact information, 85 continuous sampling, 3 119