SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

• Parameter range: 0.4 to 10 meters
• Without parameter: returns its current setting in meters.
• When used with a valid parameter, sets the blanking distance to this value.
Argonaut Operation Manual Firmware Version 7.9 (May 1, 2001)
SonTek/YSI
DynBoundaryAdj or DBA [YES|NO] (used in XR systems only)
• This command is only available in XR systems.
• Default parameter: NO
• Without parameter: returns its current setting.
• When set to YES, the XR dynamically adjusts the values of CellBegin and CellEnd to
reflect the changes in a changing water level. Examples: (1) To monitor the currents in the
upper 2 m of water below the surface, set CB to 13, CE to 15, and DBA to YES; (2) To measure
currents throughout the entire water column, set CB to 0.4, CE to 15, and DBA to YES.
• When set to NO, the XR uses the fixed cell location parameters (CellBegin and CellEnd)
entered above. Example: When monitoring currents in a fixed layer (1 m above the
bottom) set CB to 1, CE to 2, and DBA to NO.
21