SonTek/YSI Argonaut-XR Technical Manual - HydroScientific West

SonTek/YSI
Show Commands (Section 3.14)
Command Short Function
Show Conf S Conf Display hardware configuration parameters
Show System S System Display general system parameters
Show Setup S Setup Display real time data collection parameters
Show Deploy S Deploy Display autonomous deployment parameters
Run-Time Commands (Section 3.15)
Command* Short Function
+++ (none) Return to command mode (stop data collection)
O (none) Transmit last sample
T (none) Transmit Argonaut date and time
C+ (none) Adjust real-time clock +1 second
C- (none) Adjust real-time clock -1 second
A (none) Transmit time left in current averaging interval (seconds)
*These commands available only in data acquisition mode.
3.6. Help Commands
The Argonaut direct command interface contains several on-line help commands. These are
designed such that, by starting with “Help”, you are led through a series of menus that show all
Argonaut commands. Several help commands display all commands you would normally use for
any aspect of Argonaut operation.
• Help Listing of help menus available
• Help System General system commands
• Help Setup Real-time data collection commands
• Help Deploy Autonomous deployment commands
• Help Sdi12 SDI-12 interface control commands
• Help Recorder Data recorder commands
• Help Sensor Peripheral sensor commands
• Help Compass Compass/tilt sensor commands
• Help Show Commands to display system configuration
The output of these commands is self-explanatory. For more details on individual commands, see
the remaining portions of Section 3.
14
Argonaut Operation Manual Firmware Version 7.9 (May 1, 2001)