TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

DTE. [CALLI 1 70]
16 .DTEFR
Releases a front-end device.
for the .DTEFR function is:
The argument list
addr:
XWD
EXP
cpuno,dteno
fedno
17 .DTERC
Releases KL error chunks. The argument list for
the .DTERC function is:
20 .DTERT
addr: XWD cpuno,O
Releases the KL error timer.
for the .DTERT function is:
addr: XWD cpuno, a
The argument list
21 .DTEDT
Returns Universal Device Indexes for terminal
lines leading to the DL11s on the specified DTE.
The argument list for this function is:
addr: XWD cpuno,dteno
On a successful return, the UDX is returned in the
ac. However, for DTE 0, which is dedicated to the
console front end (RSX-20F), the ac contains the
KLINIK line's UDX in the left half, and the CTY's
UDX in the right half.
22 .DTESU
Specifies the type of protocol that will run on
the DTE. The argument list for this function is:
addr: XWD cpuno,dteno
SIXBIT/user-name/
where the user-name is one of the following
protocol types:
DECNET for DECnet-10.
ANF for ANF-10.
IBM for IBM communications.
NOBODY if the DTE is not running
protocol.
a
PROGRA if the DTE is dedicated to a job.
23 .DTERU
Reads the protocol type of the protocol that is
running on the DTE. The argument list is:
addr:
XWD
BLOCK
cpuno,dteno
2
The information is returned in the following
format:
addr: XWD cpuno,dteno
SIXBIT/user-name/
EXP jobn
where user-name is the name of the protocol
running on the DTE (refer to .DTESU above). The
job number (jobn) is returned in addr+2 only if
user-name is PROGRA.
22-102