TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

LATOP. [CALLI 221]
22.80 LATOP. [CALLI 221]
FUNCTION
Performs Local Area Terminal (LAT)
intended for customer use.
CALLING SEQUENCE
functions.
This function is not
addr:
MOVE I ac,addr
LATOP. ac,
error return
skip return
EXP length
function-code
argument list
In the calling sequence,
information:
the program
supplies
the
following
o
addr is the address of the argument list.
o length is the total length of the argument list including
this word
o
function-code is one of the following codes or symbols:
Function Code
Symbol
Meaning
o
.LASET Sets a LAT parameter.
1 .LACLR Clears a LAT parameter.
2 . LASCH Shows LAT characteristics.
3 .LASTC Shows terminal connects.
4 .LASAS Shows adjacent servers.
5 . LASCO Shows LAT counters.
6 .LAZCO Clears LAT counters.
7 . LARHC Requests host-initiated connect.
10 .LATHC Terminates a host-initiated connect.
11 .LASHC Shows information about host-initiated
connects.
The argument list is different for each function code.
arguments are desribed for each function code in
sections.
Therefore, the
the following
22.80.1 FUNCTION 0 (.LASET)
Sets LAT parameters for the local node. The parameters you set using
this function are dynamic parameters stored only in the host software.
Your program must have JACCT or [1,2] privileges to set LAT
parameters.
The parameters you can set with .LASET are:
Code
1
2
3
4
5
Symbol
. LPMAC
. LPMCO
. LPNUM
. LPLAS
. LPRLI
Meaning
Maximum number of active circuits.
Maximum number of simultaneous connections.
Host number .
LAT access state.
Circuit retransmit limit.
22-204