TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

LATOP. [CALLI 221]
22.80.3 FUNCTION 2 (. LASCH)
SholN's the LAT characteristics. The monitor returns a Show Buffer
containing the values of both permanent and dynamic parameters.
The argument block for this function is:
Word
o
1
2
3
Symbol
.LAACT
.LAFCN
.LABCT
.LABFA
Contents
EXP
EXP
EXP
EXP
len
. LASCH
buffer-length
buffer-addr
Where len is the length of the argument block. Specify the number of
words reserved for the Show Buffer in .LABCT, and the location of the
ShOlN' Buffer in . LABFA.
The Show Buffer is returned at the location you specified, and the
contents of .LABCT are adjusted by the monitor to reflect the actual
number of words used.
The Show Buffer is formatted as shown below.
Tab:le 22-3: LATOP. Show Buffer Format
0------------------------17 18----------------------------35
+--.--------------------~-------------------------------------+
1 Maximum alloc. circuits 1 Number of alloc. circuits
1--·----------------------------------------------------------
1 Maximum active circuits 1 Number of active circuits
1------------------------------------------------------------
\ Mamimum connects \ Number of connects
Host-number
LAT terminal access status
Host retransmit limit
Host-multicast timer
Host-circuit timer
Reserved
High-protocol version \ Low-protocol version
------------------------------------------------------------\
Protocol ECO \ Current-protocol version
Maximum slot size
Frame size
Maximum slots
Maximum services
Host group codes (8 words)
Host-name count
Host-id count
Host name (2 words)
Host-id (13 words)
Service Blocks (19 words per service, described below)
+-_._---------------------------------------------------------+
22-207