TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

LATOP. [CALLI 221]
22.80.9 FUNCTION 10 (.LATHC)
Terminates a host-initiated connection. This function requires JACCT
or [1,2] privileges. The argument list is:
Word
a
1
2
Symbol
.LAACT
.LAFCN
.LAPRM
Contents
EXP length
EXP .LATHC
Parameter word (described below)
Where the parameter word
information:
contains the following
Bits
a
1
2
3
4-17
18-35
Symbol
LA.WAI
LA. QUE
LA. SYS
LA. JOB
LA.CID
Meaning
Ignored.
Ignored.
Ignored.
If this bit is set, the
LATOP. UUO will terminate all
host-initiated requests for this
job.
Reserved for Digital.
Connect-Ide If LA. JOB
cleared, then terminate
host-initiated request for
connect-id (returned by
.LARHC function) .
is
the
this
the
22.80.10 FUNCTION 11 (.LASHC)
Shows information about host-initiated connections. This function
requires JACCT or [1,2] privileges. The argument list is:
Word
a
1
2
3
4
Symbol
.LAACT
.LAFCN
.LABCT
.LABFA
.LAQUA
Contents
EXP length
EXP .LASHC
Buffer count word. Store the length of the buffer
reserved for the information in the right half of
this word. The monitor will return the number of
words actually used in the left half of this word.
Address of the buffer where the information will
be returned
The information returned at the address specified
in .LABFA takes the form of one Status Block for
each pending connection. The format of the Status
Block is shown in Table 22-11.
Connect-id word. The word is formatted as
follows:
Bits Symbol Meaning
0-1 Ignored.
2 LA.SYS Returns information on
host-initiated connects.
18-35 LA.CID Connect-id, or zero.
22-214