TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

RECON. [CALLI 202]
In the argument list, n is the length of the
command string (in words) + 1. The command string
cannot exceed 16 words, and cannot include
line-feeds; therefore, the maximum value for n is
17. For information about the BOO TXT command
string, refer to BTXLEN in the COMMON monitor
source file.
5 . RCRLD
Causes the system to be reloaded. The monitor
will be reloaded from the file specified in
BOOTXT, and a crash dump may be taken. You must
be logged into [1,2] to use this function (JACCT
privileges alone are not sufficient) . This
function causes an RLD stopcode and does not
require an argument list. The calling sequence
for this function is:
MOVE ac, [.RCRLD"O]
RECON. ac,
error return
skip return
6 . RCRAC
Causes auto-configuration (AUTCON) to run on the
specified CPU(s) to automatically configure disks
and tapes into the monitor's data base. You must
be logged in as [1,2] to use this function. The
calling sequence for this function is:
MOVE
RECON.
error return
skip return
ac, [.RCRAC"addr]
ac,
addr: 2 ;length of argument block
n ;CPU number
In the argument list, n specifies the CPU
If n = -1, AUTCON will-run on all CPUs.
number.
7 . RCDET
10 . RCATT
11 . RCMON
Obsolete .
Obsolete
Sets a given range of memory on-line.
is given in two words of the argument
first word specifies the first page of
and the second word indicates the
beyond the range. The calling sequence
The range
block. The
the range,
first page
is:
MOVE ac, [.RCMON"addr]
RECON. ac,
error return
skip return
addr: 3 ;length of argument block
first page in range
last page in range +1
22-342