TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

DTE. [CALLI 170]
24 .DTELS
Loads a secondary bootstrap from your job's memory
area, using the PDP-11 bootstrap ROM. This
function must be preceded by the .DTECL (clear)
and .DTEPR (press reload) functions. You must
also use function .DTEDM (dump) before you can
load any bootstrap. The argument list for this
function is:
addr:
XWD
POINT
EXP
cpuno,dteno
16,addr1
length
where addr+l contains a byte pointer indicating
the location of the secondary loader, and length
is the length of the loader, in 16-bit bytes.
25 .DTEDM
Dumps PDP-II memory, using the PDP-l1 bootstrap
ROM. Before you use this function, be sure to use
functions .DTECL (clear) and .DTEPR (press
reload) . You must always dump the PDP-II memory
before you can load a program into its memory.
The argument list for this function is:
addr:
XWD
POINT
EXP
cpuno,dteno
16,addr1
count
where addr+l contains a byte-pointer to the memory
that must be dumped, and where count is the number
of 16-bit bytes to dump from the PDP-11.
26 .DTKPS
Set KLINIK parameters.
use. )
(Not intended for customer
27 .DTKPR
SKIP RETURN
Read KLINIK parameters.
customer use.)
(Not intended for
The function is performed, and any requested value is stored in the
ac.
ERROR RETURN
One of the following error codes is returned in the ac:
Code
Symbol
1 DTENP%
2 DTEUF%
3 DTEDC%
4 DTEAP%
5 DTEPT%
6 DTEDE%
7 DTTTE%
10 DTEDD%
11 DTEIJ%
12 DTEIB%
13 DTENI%
14 DTEFB%
15 DTENF%
16 DTEFE%
17 DTESE%
20 DTENC%
Error
Not enough privileges.
Illegal function code.
Illegal CPU or DTE number.
Primary protocol already running.
Power fail did not come up.
Doorbell did not clear.
To TOPS-I0 error during BOOT sequence.
No response from PDP-II after BOOT sequence.
Illegal job number.
Illegal byte count. .
Front-end device not initialized.
Front-end device in use by another job.
Nonexistent front-end device.
Fatal error on front-end device.
Error starting primary protocol.
No free core for front-end device buffers.
22-103