TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

PISYS. [CALLI 136]
The function flags and their meaning~ are list~d below.
Table 22-13: PISYS. Function Flags
Bits
Symbol
Meaning
1 PS.FOF
2 PS.FON
3 PS.FCP
4 PS.FCS
5 PS.FRC
6 PS .FAC
Turns off the interrupt facility.
Turns on the interrupt facility.
Clears all pending interrupts.
Clears all pending interrupts for a given device
or condition.
Removes the specified device or condition.
Adds the specified device or condition.
The non-I/O condition codes and their meanings are listed in the
following table. You can include these codes in addr to enable PISYS.
interrupts.
Table 22-14:
PSI Interrupt Codes (Non-I/O Interrupts)
Code
Symbol
Meaning
-1 .PCTLE
Time limit exceeded for non-batch job. The job
run time (in milliseconds) is returned in the
status word. You can change the job's time
limit with the SET TIME monitor command.
-2 .PCTMR
Timer interrupt occurred.
condition with PISYS.,
control timer interrupts.
After you enable this
use the PITMR. call to
-3 .PCSTP
-4 .PCUUO
CTRL/C received from user terminal. If the job
was in terminal input wait state, bit 0 of the
status word is set.
A monitor call is about to be processed; the
status word contains the monitor call.
-5 .PCIUU
An illegal monitor call has been processed;
status word contains the monitor call.
the
-6 .PCIMR
An illegal memory reference occurred; the status
word contains the effective address.
22-318